A collecting forum. CollectingBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » CollectingBanter forum » Collecting newsgroups » Juke Boxes
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Setting NSM to FreePlay



 
 
Thread Tools Display Modes
  #1  
Old December 26th 03, 04:52 PM
Ian_UK
external usenet poster
 
Posts: n/a
Default Setting NSM to FreePlay

I have a NSM Prestige ES160 and I want to set it to freeplay. The manual
says switch the Key Switch and program C3 to 000 00...I don't have a key
switch. Can anyone help me set the juke please?
Many thanks
Ian_UK


Ads
  #2  
Old December 27th 03, 04:00 PM
Rick Force
external usenet poster
 
Posts: n/a
Default

"Ian_UK" wrote in message ...
I have a NSM Prestige ES160 and I want to set it to freeplay. The manual
says switch the Key Switch and program C3 to 000 00...I don't have a key
switch. Can anyone help me set the juke please?
Many thanks
Ian_UK


Hi Ian,
you'll have to either buy or make that key sw. I made mine from an old
PC keyboard lock sw. It uses the same connector type that NSM uses,
but you need a 2 pin connector and the PC keybrd connector is 4 (2
blanks), so you;ll need to carefully cut off the blank portion of this
connector. Once done, just plug it into the key switch jack (check
your manual for location), but on my City 2, it was on the the left
side of the computer module, I think (don't have that juke anymore to
look at it) it's the middle jack (the 2 pin one). You can also just
juper (short) the 2 pins together with an allagator clip wire...that
would be the easiest, then you can enter the programme section and set
it to free play. It will display "FREE" in the display if done
correctly. Hope someone hasn't changed the "electronic key" from
00000, otherwise, you can't access the programme sections of the
computer. Good luck, Rick.
  #3  
Old December 27th 03, 04:26 PM
Ian_UK
external usenet poster
 
Posts: n/a
Default

Many thanks, Rick. I will try that. I am not familiar with the settings on
my Pretsige jukebox yet. It comes up with C0 when you enter the service
settings, not the CE which I believe it should to let you enter the
electronic code. I can get to the C3 (freeplay code)from C0 but I am not
quite sure what to do to save the setting.
Thanks for the help with the switch. I will try a jumper to short the pins
next.
Thanks again
Ian
"Rick Force" wrote in message
om...
"Ian_UK" wrote in message

...
I have a NSM Prestige ES160 and I want to set it to freeplay. The manual
says switch the Key Switch and program C3 to 000 00...I don't have a key
switch. Can anyone help me set the juke please?
Many thanks
Ian_UK


Hi Ian,
you'll have to either buy or make that key sw. I made mine from an old
PC keyboard lock sw. It uses the same connector type that NSM uses,
but you need a 2 pin connector and the PC keybrd connector is 4 (2
blanks), so you;ll need to carefully cut off the blank portion of this
connector. Once done, just plug it into the key switch jack (check
your manual for location), but on my City 2, it was on the the left
side of the computer module, I think (don't have that juke anymore to
look at it) it's the middle jack (the 2 pin one). You can also just
juper (short) the 2 pins together with an allagator clip wire...that
would be the easiest, then you can enter the programme section and set
it to free play. It will display "FREE" in the display if done
correctly. Hope someone hasn't changed the "electronic key" from
00000, otherwise, you can't access the programme sections of the
computer. Good luck, Rick.



  #4  
Old December 27th 03, 05:29 PM
Merlin Amusements
external usenet poster
 
Posts: n/a
Default

just make a jumper plug where it plugs into the computer. You don't have to
have a key switch. Freeplay also has to be programmed in.
Mike

"Ian_UK" wrote in message
...
Many thanks, Rick. I will try that. I am not familiar with the settings on
my Pretsige jukebox yet. It comes up with C0 when you enter the service
settings, not the CE which I believe it should to let you enter the
electronic code. I can get to the C3 (freeplay code)from C0 but I am not
quite sure what to do to save the setting.
Thanks for the help with the switch. I will try a jumper to short the pins
next.
Thanks again
Ian
"Rick Force" wrote in message
om...
"Ian_UK" wrote in message

...
I have a NSM Prestige ES160 and I want to set it to freeplay. The

manual
says switch the Key Switch and program C3 to 000 00...I don't have a

key
switch. Can anyone help me set the juke please?
Many thanks
Ian_UK


Hi Ian,
you'll have to either buy or make that key sw. I made mine from an old
PC keyboard lock sw. It uses the same connector type that NSM uses,
but you need a 2 pin connector and the PC keybrd connector is 4 (2
blanks), so you;ll need to carefully cut off the blank portion of this
connector. Once done, just plug it into the key switch jack (check
your manual for location), but on my City 2, it was on the the left
side of the computer module, I think (don't have that juke anymore to
look at it) it's the middle jack (the 2 pin one). You can also just
juper (short) the 2 pins together with an allagator clip wire...that
would be the easiest, then you can enter the programme section and set
it to free play. It will display "FREE" in the display if done
correctly. Hope someone hasn't changed the "electronic key" from
00000, otherwise, you can't access the programme sections of the
computer. Good luck, Rick.





 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
reality setting in or second thoughts ?? trippin28track 8 Track Tapes 0 November 2nd 04 11:26 AM
Setting up a new free links site........ VinnyH Autographs 1 November 23rd 03 08:17 PM
Rock-ola 454 freeplay Ron Lyons Juke Boxes 1 September 5th 03 03:05 AM
Setting Free Play on NSM ES160 series? Michael Lenardon Juke Boxes 2 September 3rd 03 10:13 AM
Help setting free play on NSM City II Michael Lenardon Juke Boxes 1 September 2nd 03 10:07 AM


All times are GMT +1. The time now is 10:31 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright 2004-2014 CollectingBanter.
The comments are property of their posters.