If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Seeburg--SMC1 slow scan
I picked up a Seeburg SMC1 from someone that never had it working....He
bought it from someone who told him it needed a new motor on the mech...I'm not so sure....when you power the unit on the mech scans very slowly to one side then stops, by slowly I mean it takes about a minute to scan to one side. When I was checking the contacts to make sure none were "welded" together, I accidently touched the mech body with my screwdriver while touching the trip contacts and the unit took off and scanned at a regular speed. Any ideas what may be causing this? Bad ground, and where to look? Any help would be greatly apprectiated. |
Ads |
#2
|
|||
|
|||
Seeburg--SMC1 slow scan
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Albion Stamps Mailing List | VSAndrew | Marketplace | 0 | January 27th 04 07:13 PM |
Albion Stamps Mailing List | VSAndrew | Worldwide Stamps | 0 | January 27th 04 07:07 PM |
Albion Stamps Mailing List | VSAndrew | US Stamps | 0 | January 27th 04 07:07 PM |
$5,000 Rookie Card Auction ENDS TONIGHT | Jonathan Banks | Baseball | 0 | October 23rd 03 04:58 PM |
[Fwd: FA Stampoffers] | Doug Buss | Marketplace | 0 | October 11th 03 02:24 AM |