If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
FA: 1-Day, Machinists Jacobs Drill Chuck, ½ inch Arbor, No. 6
Machinists Jacobs Drill Chuck, ½ inch Arbor, No. 6
1-Day Left on Ebay............. This ½ inch Jacobs Drill Chuck, No. 6, is in excellent condition. It is used. The chuck measures 5 ½ inches long x 2 inches in diameter. The shaft measures ½ inch in diameter. It is marked on the side, (Jacobs Drill Chuck, Pat. Sept. 16, 1902, The Jacobs Mfg. Co., Hartford, Conn., USA, No. 6). There is also a stamped (3) on the spindle. The chuck is in excellent full operational condition. There is no rust or pitting. There is no chuck key (easily obtainable). To see pictures, please view at: http://cgi.ebay.com/aw-cgi/eBayISAPI...tem=7609672021 |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FA: Machinists Jacobs Drill Chuck, ½ inch Arbor, No. 6 | fishnet | General | 0 | April 12th 06 11:51 PM |
Fun Facts About Chuck Norris | Señor Coconut | Coins | 15 | February 26th 06 05:30 AM |
1961 Topps #13, Chuck Cottier | John Wade | Card discussions | 1 | December 28th 04 08:41 PM |
FS: Various Cards (2 of 3) | Max Gratton | Baseball | 0 | September 30th 04 03:56 AM |