Rowe cd100 remote wires-wireless

Hi Group,
I am installing a wireless remote on my rowe cds 100. The remote kit did not
come with a manual, and my jukes owners manual was printed before the remote
came out. My question is off the remote brain inside the box there are three
wires coming off, a black with white trace, a green, and a red, can someone
tell me which lugs these wires are supposed to go to.
Thank you,
Brian

On Tue, 20 Apr 2004 23:30:50 GMT, "BriMc"
wrote:

Hi Group,
I am installing a wireless remote on my rowe cds 100. The remote kit did not
come with a manual, and my jukes owners manual was printed before the remote
came out. My question is off the remote brain inside the box there are three
wires coming off, a black with white trace, a green, and a red, can someone
tell me which lugs these wires are supposed to go to.
Thank you,
Brian




none of the rowe manuals tell you how to install the IR remote - the
directions come with the IR kit

the red and green wires are to go to each volume control, one wire is
the left the other is the right.


if you want single - you use one wire only - but Im not sure which -
the 4 way dip switch sets whether you want the machine stereo - or 2
channel mono with one control for each channel (so for example if you
want 2 sets of speakers in separate rooms and separate volume control
for each)


disconnect the existing volume pot from the terminal strip - and
attatch the red wire from the remote control box to where the red wire
from the pot was connected.

try and adjust the volume via the IR - if no luck then remove the red
and try the green instead.


The black/white wire is used as an earth wire - but you arent supposed
to connect it to earth unless you have audio hum problems. (take it
to the terminal that is the common for the remote volume pot/cancel
switch if you do have hum)