A collecting forum. CollectingBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » CollectingBanter forum » Collecting newsgroups » Juke Boxes
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Write in problem: Seeburg L-100



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old May 15th 10, 05:46 PM posted to alt.collecting.juke-boxes
Grojohn
external usenet poster
 
Posts: 19
Default Write in problem: Seeburg L-100

I have a write in problem.

I have the manual, but the tests are for models 101,161, and 201. My
TEU board and RCSU1 board have the same test points, so I think the
tests are will work.

Ok, Test B works; Thats when i unplug the memory unit RCA jack, do a
scan and touch from test point C to the inside socket for the memory
unit on the TEU board. GOOD!

Next, test C works, the battery trick; GOOD!

Now it tells me to use test G to pinpoint.

Test G tells me to connect a test lamp from point D to A. This is
from the write in points(D) to ground (A).
My lamp does not glow and i make a selection and my lamp does not
glow, so it tells me to go to test J.

(my lamp is homemade; its a 28volt lamp with leads, and I tested it
with a 9 volt power supply and it did light)

Ok, onward to test J. I remove the jumper between test points D and E
and hook up my lamp. It does NOT show a dim glow. Its says it lamp
does NOT glow, replace "selection receiver (defective write in
electronics)".

SO, im guessing that my selection reciever is my TEU board.

Im getting good voltages -300 is about -298. The -150 is about -149,
and the -147 on the anode of the diode is there. The cathode to ground
measures 0 volts. Also, i pulled the diode and tested with meter and
it seems ok.

I have inspected and tested signals all the way up to the RCSU1. I
repaired the wiper contact on the SPU1.

I have also recapped the TEU board, but did not replace any tubes.

HELP!

John





 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Seeburg R Problem [email protected] Juke Boxes 1 February 4th 07 02:49 PM
LS2 write in voltage problem HELP!!!! :) [email protected] Juke Boxes 1 November 24th 06 09:18 PM
seeburg 3w1 com problem [email protected] Juke Boxes 2 April 6th 06 04:34 PM
Seeburg AY160 Amp Problem [email protected] Juke Boxes 3 November 16th 04 02:18 PM
HELP! Seeburg USC2 Problem DJ Juke Boxes 2 September 17th 04 12:55 AM


All times are GMT +1. The time now is 05:41 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 CollectingBanter.
The comments are property of their posters.