If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
General Help and Trashcan #20 problem
New to this message board, but 15 years experience with all jukebox
types. I prefer Rockola, but own and repair any and all from the 30's-60's. I am located in N. California and check message boards 3 or 4 times a week. If you have a jukebox question or have something you want information on, send me and email at: If I can help I will. For the person with a #20 trashcan tray problem, I would suspect the mech jammed and bent the cam follower used to lower the turn table. Pull the shaft and remove the arm and you can gently bend it back or find a replacement. There may also be a shoulder type screw for minor adjustments to raise or lower the lift arm, but 9 times out of ten, the machine has jammed on the way down and bent the cam follower arm. Scott |
Ads |
Thread Tools | |
Display Modes | |
|
|