If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Pen running dry
Here's an annoying problem. I hope someone has an easy fix for me.
BTW I'm kicking myself for not finding this group years ago. My daily workhorse is a perfectly adjusted (luck, not adjusting) Sheaffer Prelude. Writes like a dream with a nice wet medium line - for about three pages. Then, the flows starts to dry up, the colour turns lighter, the nib scratches until about a page later when it becomes a nail with no ink. At that point I have two choices. Either let it rest for a day or so, which will bring it back to normal, or twist the converter FORCING ink to the nib. What's up with that? Is this normal, is there a fix? None of my other Sheaffer's do that. Thanks. BTW - who's a reputable person to do tine adjustment on an older Imperial that's become mis-aligned? How much will that cost? |
Ads |
#2
|
|||
|
|||
morten wrote:
... Either let it rest for a day or so, which will bring it back to normal, or twist the converter FORCING ink to the nib. What's up with that? Is this normal, is there a fix? None of my other Sheaffer's do that. Not normal but common with some converters. The problem is probably the converter. The walls of the converter essentially hold the liquid in place and prevent it from slipping down into the feed. You can test this theory by plugging a cartridge in the pen and seeing if it does the same thing. If it doesn't, the problem is the converter. You can attempt wetting the walls of the converter with a couple drops of liquid diswashing detergent diluted in a small glass of water. This is a temporary fix. I'd send it back to Sheaffer and exchange it for new converter or just order a new converter... this after running the test with the cartridge. BTW - who's a reputable person to do tine adjustment on an older Imperial that's become mis-aligned? How much will that cost? You can send it out to someone, but learn how to do it yourself. It's not hard to do and it'll save you lots of $$$. You can buy Frank Dubiel's repair manual or there may be some references on-line explaining how to align a nib. --- Bernadette |
#3
|
|||
|
|||
I had the same problem with an Aurora, about 3 pages,
and did the same thing with the piston fill to get it going again. I sent it back and they replaced the nib, it is definitely a defect. Knowing nothing I believe that it is a defect in the air return part of the nib, ink flows out, air can't flow back, a vacuum is created that stops the ink flow until the pen is "burped" using the piston. No experience with Scheaffer but my experience with both Waterman and Aurora has been excellent insofar as service. Good luck. JP "morten" wrote in message m... Here's an annoying problem. I hope someone has an easy fix for me. BTW I'm kicking myself for not finding this group years ago. My daily workhorse is a perfectly adjusted (luck, not adjusting) Sheaffer Prelude. Writes like a dream with a nice wet medium line - for about three pages. Then, the flows starts to dry up, the colour turns lighter, the nib scratches until about a page later when it becomes a nail with no ink. At that point I have two choices. Either let it rest for a day or so, which will bring it back to normal, or twist the converter FORCING ink to the nib. What's up with that? Is this normal, is there a fix? None of my other Sheaffer's do that. Thanks. BTW - who's a reputable person to do tine adjustment on an older Imperial that's become mis-aligned? How much will that cost? |
#4
|
|||
|
|||
"BLandolf" wrote in message ...
morten wrote: ... Either let it rest for a day or so, which will bring it back to normal, or twist the converter FORCING ink to the nib. What's up with that? Is this normal, is there a fix? None of my other Sheaffer's do that. Not normal but common with some converters. The problem is probably the converter. The walls of the converter essentially hold the liquid in place and prevent it from slipping down into the feed. You can test this theory by plugging a cartridge in the pen and seeing if it does the same thing. If it doesn't, the problem is the converter. You can attempt wetting the walls of the converter with a couple drops of liquid diswashing detergent diluted in a small glass of water. This is a temporary fix. I'd send it back to Sheaffer and exchange it for new converter or just order a new converter... this after running the test with the cartridge. OK, I'll run that test. Will my local FP store be able to get me a converter, or is that a specialty item? |
#5
|
|||
|
|||
morten wrote:
OK, I'll run that test. Will my local FP store be able to get me a converter, or is that a specialty item? Your local fountain pen store should have one on hand. If not, you can order one from almost any on-line pen dealer. Popping a cartridge in there is an inexpensive, easy way to rule-out a problem with the converter. So, has your pen always written this way or did it develop the problem over time? --- Bernadette |
#6
|
|||
|
|||
(morten) writes:
OK, I'll run that test. Will my local FP store be able to get me a converter, or is that a specialty item? Don't know your local fountain pen store, but all major pen emporiums will have converters in stock or will obtain same as per request. Converters are very inexpensive... anytime anyone purchases a new pen they should also purchase an extra converter or at least have an extra for each brand of pen they have. Also, some converters are interchangeable. ---= BOYCOTT FRANCE (belgium) GERMANY--SPAIN =--- ---= Move UNITED NATIONS To Paris =--- ********* "Life would be devoid of all meaning were it without tribulation." Sheldon ```````````` |
#7
|
|||
|
|||
"JP" wrote in message .. .
I had the same problem with an Aurora, about 3 pages, and did the same thing with the piston fill to get it going again. I sent it back and they replaced the nib, it is definitely a defect. Knowing nothing I believe that it is a defect in the air return part of the nib, ink flows out, air can't flow back, a vacuum is created that stops the ink flow until the pen is "burped" using the piston. No experience with Scheaffer but my experience with both Waterman and Aurora has been excellent insofar as service. Good luck. JP Good advice all. I'll try a new converter, then if that fails take advantage of the White Dot guarantee. Hopefully thaey won't decide to replace the nib or pen, as the nib on that Prelude is perfect. |
#8
|
|||
|
|||
|
#9
|
|||
|
|||
I will admit that I flushed the pen out thoroughly and repeatedly
with water and with the water and ammonia mix prior to sending it in, over a dozen times .. I also omitted that the service department did the same on my first return sending it back with the problem unresolved. I suppose that in most cases a simple cleaning does work, that most fp purchasers are ignorant in basic maintenance. I came to my own theoretical conclusion after studying "da book" and it's diagrams. (I also came to the conclusion that I would leave repair to acknowledged experts and pursue expertise in those areas I was already involved__but "da book" is fascinating in any case) JP "Juan" wrote in message om... (morten) wrote in message om... "JP" wrote in message .. . I had the same problem with an Aurora, about 3 pages, and did the same thing with the piston fill to get it going again. I sent it back and they replaced the nib, it is definitely a defect. Knowing nothing I believe that it is a defect in the air return part of the nib, ink flows out, air can't flow back, a vacuum is created that stops the ink flow until the pen is "burped" using the piston. No experience with Scheaffer but my experience with both Waterman and Aurora has been excellent insofar as service. Good luck. JP Good advice all. I'll try a new converter, then if that fails take advantage of the White Dot guarantee. Hopefully thaey won't decide to replace the nib or pen, as the nib on that Prelude is perfect. I had the same problem with 2 sheaffer balance II. Cartridges had the same problem in my case. After 2 trips to the repair service (with no success), I solved the problem by flushing the pens well with water and a few drops of dishwasher. I had done that before sending to repair, but my pens needed a few flushes more. It seems the feeders (probably also the converter) had a layer of oil or grease or anything. Juan |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
hohohahaheeheehaha up and running again | Barefootmk | Autographs | 6 | February 4th 05 07:25 PM |
newsgroups in 2004. are you all slowly running out of air ? | Forgnog Zambrucken | 8 Track Tapes | 4 | May 10th 04 11:48 AM |
running low on ink...how to fill? | Adam Bailey | Pens & Pencils | 11 | March 29th 04 02:59 AM |
Rowe/ami mm3 running backwards | Mark | Juke Boxes | 6 | February 2nd 04 02:04 PM |
Enter-Net Auction: Running again - News | w.kleinh | Pens & Pencils | 0 | November 20th 03 07:13 PM |