If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
volume control HELP!!!!!
HELP !!!!!!!
I need a schematic or instructions on building a volume control for a rockola 56180-A amplifier, I have read that this unit came out of a 2000xcd juke but I have no volume control. Any help would be greatly appreciated.... |
Ads |
#2
|
|||
|
|||
ELEC,
You will need a 10K Ohm 1/4W(?) potentiometer with the center leg wired for the ground terminal on the strip on bottom front of amp. Wire one of the outside legs to the Volume In (far left terminal on the strip) and daisy chain it to the next two. You can attach the same ground wire to a N.O. pushbutton switch and wire other side of switch to the Cancel terminal on amp strip. NOTE: The closer the Volume signal approaches ground potential, the lower the volume. If you want to make the VC mechanically correct (Clockwise increase in volume) you will need to wire accordingly. David |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AMI Remote Volume Control | Brian Roth | Juke Boxes | 1 | January 21st 08 12:55 AM |
AMI F Volume Control | map55b | Juke Boxes | 2 | June 24th 07 08:54 PM |
WTB cabinet volume control for Rowe Jan/Jao 200 | Rick Force | Juke Boxes | 1 | November 5th 04 02:05 AM |
FA: VOLUME CONTROL BOX | MARK | Juke Boxes | 0 | October 21st 03 07:16 PM |
FA:VOLUME CONTROL BOX LIKE NEW | MARK | Juke Boxes | 0 | October 17th 03 11:07 PM |