If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
ami-D-40
i am working on a model -40 ami jukebox. It was sold to me as a 45rpm
but it looks just like my 78 rpm i have. the wire from the tone arm to the amp is broken. it has a two hole plug where it plugs into the amp. i have another d-40 but it only has a one hole plug. can someone tell me the difference. i also need the shaft that goes through the transfer mechanism. its the shaft assembly the tone arm sits on and moves the tone arm when transferring also need the tone arm wiring to the amp but itmust be a two hole plug. thanks for reading. |
#2
|
|||
|
|||
ami-D-40
Someone probably changed the input jack & plug on one of your amps
unless ami upgraded , downgraded , changed their minds . |
#3
|
|||
|
|||
ami-D-40
On Aug 9, 9:26*pm, (Ken G.) wrote:
Someone probably changed the input jack & plug on one of your amps unless ami upgraded , downgraded , changed their minds . i thoiught all d-40s were 78s but according to the manual i have ami did make d-40 45 machines. i also have a spare amp that i bought a few years ago and it also has the2 prong plug. i thought maybe that setup was inclusive to the 45 system. thanks norm |
#4
|
|||
|
|||
ami-D-40
The D-80 was the 45 machine. 80 selections, no mirrors between the buttons.
Both are shown on the pinballrebel page: http://www.pinballrebel.com/archive/ami/d40/d40.htm Ken D. "em pinball" wrote: i thoiught all d-40s were 78s but according to the manual i have ami did make d-40 45 machines. i also have a spare amp that i bought a few years ago and it also has the2 prong plug. i thought maybe that setup was inclusive to the 45 system. thanks norm |
Thread Tools | |
Display Modes | |
|
|