|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 8th 03, 02:04 AM
|
|||
|
|||
multiple Jukeboxes and external speakers
I was wondering if any of you did this or if it's possible with out
hurting anything. Let's say you have two Jukes, 1 is a Wurli 1015 and the other a Seeburg 100C and you want to run external speakers through out the house, but you want these external speakers to work for both boxes, so if one is played it comes out of the same external speaker as when the other one is played. No switches or nothing. Now is this possible to do with out doing harm to either of the amps? And is there a voltage difference between the two? Bernie 
|
| Ads |
|
#2
July 8th 03, 02:27 AM
|
|||
|
|||
|
what i would do is to get a set of relays so if one box is on the other
will be cut off thats one way to be safe ! Jim W "Bernie" wrote in message om... I was wondering if any of you did this or if it's possible with out hurting anything. Let's say you have two Jukes, 1 is a Wurli 1015 and the other a Seeburg 100C and you want to run external speakers through out the house, but you want these external speakers to work for both boxes, so if one is played it comes out of the same external speaker as when the other one is played. No switches or nothing. Now is this possible to do with out doing harm to either of the amps? And is there a voltage difference between the two? Bernie
|
|
#3
July 8th 03, 04:08 AM
|
|||
|
|||
|
Do not run a TUBE amp with out a load..George
Happy Seeburg Olympian Owner wrote in message thlink.net... what i would do is to get a set of relays so if one box is on the other will be cut off thats one way to be safe ! Jim W "Bernie" wrote in message om... I was wondering if any of you did this or if it's possible with out hurting anything. Let's say you have two Jukes, 1 is a Wurli 1015 and the other a Seeburg 100C and you want to run external speakers through out the house, but you want these external speakers to work for both boxes, so if one is played it comes out of the same external speaker as when the other one is played. No switches or nothing. Now is this possible to do with out doing harm to either of the amps? And is there a voltage difference between the two? Bernie
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
