If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
AMi H won't select anything starting with G
Hi there,
Over the Christmas break I have been re-commissioning my AMI H200e after several years of non-use since we moved house. It is mostly working with a few quirks that need ironing out, but the one that I cannot get to the bottom of is that it will not select anything on the G column (i.e. selections G1 to G20). Any ideas where I should look for this one? Cheers, Tom. -- Tom Harvey____________________________________________ _______________ |
Ads |
Thread Tools | |
Display Modes | |
|
|