If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Seeburg VL200 needle adjustment question
Sorry, this may seem like a dumb question as I know very little about
jukeboxes. I have a Seeburg VL200 which has a gray and white plastic end piece with a needle on either side. One of the needles is loose and will not slip back into the arm. How do I go about doing this? Can I change the tension on the needle?? or do I need to replace something? Thanks in advance for your help. Dana |
Ads |
#2
|
|||
|
|||
Seeburg VL200 needle adjustment question
I hope someone emailed you some help . this message is old with no
answers . If the needle assembly (which is usually a small plastic thing with the needle in it) wont go in the arm ( or cartridge ) then its probably bent somehow . If its loose then it must go in still . Not clear what you have going on there . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seeburg A lift arm adjustment Question | william hill | Juke Boxes | 1 | February 2nd 07 03:28 AM |
Seeburg 100 - dressing contact adjustment | Brent | Juke Boxes | 0 | April 16th 04 02:57 AM |
WTB: Seeburg V200 or VL200 amp | CA Gale | Juke Boxes | 0 | November 25th 03 01:11 AM |
Seeburg V200 / VL200 | CA Gale | Juke Boxes | 0 | November 16th 03 07:10 AM |