|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 31st 03, 07:33 PM
|
|||
|
|||
TECH: AMI Continental 1 mech problem
I have just about got everything tweeked out of this mech except for the
reset of selection buttons. More often than not when you make a selection the buttons will stay pushed in. The latch solenoid and relay work fine and the manual reset button and circuitry works fine. What I notice is that when it does this the sprag relay is staying energized after a selection is made. Have any of you had a similar problem with the sprag relay staying closed? TIA Mike in Dallas 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rock ola 1448 problem....tech question | Vic Camp | Juke Boxes | 2 | December 22nd 03 06:25 PM |
| WTB: mech cover for AMI Continental 1 or 2 | mike | Juke Boxes | 0 | November 25th 03 02:38 PM |
| NSM Prestige ES160 mech wanted | Jjmscf | Juke Boxes | 0 | August 31st 03 10:41 PM |
| TECH: Rowe/AMI CMM1 Cadette magazine turning problem | Scott H. | Juke Boxes | 1 | July 29th 03 04:22 PM |
| TECH: Seeburg M100A Motor problem | Nick Guerra | Juke Boxes | 2 | July 5th 03 07:19 AM |
Linear Mode
