If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
My Rockola turntable motor is starting to fail?
Hello all. I have a Rockola 424 from 1964 and my turntable motor sometimes stops and will go a little slow. When it stops I can hand turn the tumbler and it will start back up again. I put new grommets in. I tried to remove the motor from the mechanism but the space is too tight. Can I, or should I, oil the motor without taking it apart? And what areas would I oil? I probably need a new motor but as I said I can't get mine out! Any advice would be appreciated.
Thanks Felix |
#2
|
|||
|
|||
My Rockola turntable motor is starting to fail?
On 2018/02/04 12:49 PM, Felix Cartwright wrote:
Hello all. I have a Rockola 424 from 1964 and my turntable motor sometimes stops and will go a little slow. When it stops I can hand turn the tumbler and it will start back up again. I put new grommets in. I tried to remove the motor from the mechanism but the space is too tight. Can I, or should I, oil the motor without taking it apart? And what areas would I oil? I probably need a new motor but as I said I can't get mine out! Any advice would be appreciated. Thanks Felix A drop of motor oil (20W non-detergent - for example 3-in-1 BLUE can (not regular) oil) and the bottom of the spindle shaft where it comes out of the bearing is good. If you see that there is a fabric wick around the bearing then add a few drops (don't soak so it drips). Then see if there is a thin brass tube beside the motor with a widened opening, this is the oil tube for the bottom motor bearing. Perhaps ten drops or so - if too much simply put a rag under to catch the drips. Take great care to not get any oil on the spindle shaft itself where is gets close to the idler wheel otherwise it will just oil the idler wheel and nothing will move until you clean it off. John :-#)# -- (Please post followups or tech inquiries to the USENET newsgroup) John's Jukes Ltd. MOVED to #7 - 3979 Marine Way, Burnaby, BC, Canada V5J 5E3 (604)872-5757 (Pinballs, Jukes, Video Games) www.flippers.com "Old pinballers never die, they just flip out." |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WTB: Turntable motor for Rowe R81 | Klickit | Juke Boxes | 12 | June 25th 11 03:11 AM |
Wurl. 2304 Turntable Motor | KIR | Juke Boxes | 1 | June 19th 09 09:08 PM |
AMI D80 turntable motor | bob t | Juke Boxes | 2 | April 25th 08 02:28 AM |
AMI? Rockola turntable motor-part # 233579-4-A | [email protected] | Juke Boxes | 4 | February 19th 06 05:40 AM |
AMI 'K' and Continental turntable motor question | Marc W. Howard | Juke Boxes | 0 | July 5th 03 08:07 AM |