PS: check the grey box connections also

Jim W


"Happy Seeburg Olympian Owner" wrote in
message k.net...
The same thing happend to mine.


it was the RCA jack had a broken wire in it check the whole cable for
nicks if it shorts agains the metal it wont trip the mech properly
make
sure the rRCA jack is clan and making good contact

make a slection see if it picks it up

if not:

with the upper door open make a slection or just start the mech from
service switch unplug the RCA jack while it is scanning and plug it back
in it should pick up a slection if it does the that is not the
problem
it may be further in the DCC.

Jim W


"Terry Kuhns" wrote in message
om...
I have a Seeburg SPS160 with a problem I hope someone can help me
figure out...the machine will start up fine but when you punch in a
selection the carriage (?) will run back and forth one or two times
and then stop without picking out the selection. The owner told me it
used to work fine but over time it started acting up now and then but
has now gotten to the point where it will not pick up any selection.

So far I have cleaned the bar (the one with the solid brass rail and
the row of round "dots") and the leaf switches but that did not make
any difference. I can manually make it pick up a record and it plays
just fine and will reject the record when you push the reject button.

Can someone tell me where I need to start with this problem or what to
look for?

Thanks in advance,
Terry Kuhns