View Single Post
  #2  
Old December 27th 03, 05:00 PM
Rick Force
external usenet poster
 
Posts: n/a
Default

"Ian_UK" wrote in message ...
I have a NSM Prestige ES160 and I want to set it to freeplay. The manual
says switch the Key Switch and program C3 to 000 00...I don't have a key
switch. Can anyone help me set the juke please?
Many thanks
Ian_UK


Hi Ian,
you'll have to either buy or make that key sw. I made mine from an old
PC keyboard lock sw. It uses the same connector type that NSM uses,
but you need a 2 pin connector and the PC keybrd connector is 4 (2
blanks), so you;ll need to carefully cut off the blank portion of this
connector. Once done, just plug it into the key switch jack (check
your manual for location), but on my City 2, it was on the the left
side of the computer module, I think (don't have that juke anymore to
look at it) it's the middle jack (the 2 pin one). You can also just
juper (short) the 2 pins together with an allagator clip wire...that
would be the easiest, then you can enter the programme section and set
it to free play. It will display "FREE" in the display if done
correctly. Hope someone hasn't changed the "electronic key" from
00000, otherwise, you can't access the programme sections of the
computer. Good luck, Rick.
Ads