View Single Post
  #7  
Old March 5th 14, 09:26 AM posted to alt.collecting.8-track-tapes
Andy
external usenet poster
 
Posts: 117
Default Channel Master 8-track player makes a flapping noise when trying to play tapes

lisa can you post a picture of youre unit would love to see it.


"detonator" wrote in message
...
On Tuesday, March 4, 2014 4:18:06 AM UTC-5, Andy wrote:
It could mean but i would try a product called Zoom Spout oil its made
for

motors and the like.



--

AL'S COMPUTERS

"detonator" wrote in message

news:...

On Tuesday, February 25, 2014 2:32:04 PM UTC-5, DeserTBoB wrote:

On Fri, 21 Feb 2014 12:37:34 -0800 (PST), detonator




wrote:








On Wednesday, February 5, 2014 11:15:36 PM UTC-5, detonator wrote:




Hi. I have a Channel Master Model 6325 8-track player. As I was
playing


a tape in it recently the player began to all of a sudden start to
make


a flapping noise. No audio would come through but when I took a look


inside I could see that the pulley and flywheel were indeed still


moving. If I took the belt off, and triggered the motor the flapping


sound would go away with only the flywheel moving. If the belt is on


the flapping sound is there. However, there is no evident problem
with


the belt itself, no tears, and not broken. It looks to be still like


new and this belt was replaced within the past decade. It is clean.
I


tried to check if it was a loose belt issue by using a rubber band
that


is smaller than the belt size to run it but the same flapping sound


occurred. I also tried using compressed air to clean the inside and


squirted oil into any holes in the flywheel with WD-40. So without
any


belt only the flywheel moves and there is no noise but with the
belt,


the pulley moves




too




and seems to be the cause of the flapping noise. If I tried to move
the


pulley manually I can hear the flapping noise also if I speed it up.
I've


tried a few tapes and no audio would come through from them, just the


flapping noise. What could be the cause? Is it something under the


pulley? Is it the bearings? Would the bearings be inside the pulley or


underneath? I tried to remove the pulley to see if anything needs


tightening under there but I don't see how to get it off the spindle?.


Thank you for any help or ideas.








Hi. I want to amend some things from my previous post. I realize now
that


the tape I was playing when the sound started to occur had a broken
post


where the roller sat. I had found the broken piece so it's not stuck
in


the machine but the player continues to make this spinning sound like


it's the flywheel or pulley. I do hear sound now from my tapes but not


without this loud sound of something spinning which I guess must be


either the flywheel or pulley. Again, would the bearings still be the


cause of this?








First off, NEVER use WD-40 as a lubricant. It is a water displacer,




nothing more. Use light amber machine oil or turbine oil for




lubricating the capstan/flywheel bushing. You may be hearing that




"spinning" noise because of inadequate lubrication from the WD-40.




I had the noise issue before even using the WD-40. I guess I could try to

lubricate with light amber machine oil or turbine oil but if the noise is

still there then would that mean the bearings are gone? Any ideas are

greatly appreciated.

Lisa


Thanks. I will get some of that and try it out.
Lisa



Ads